Evaluation Boards

The download package holds Demo Applications for several widely spread evaluation boards. All basic features are included for getting your rapid prototyping control scheme started. Simply open the Xcos model of the respective Demo Application and follow the instructions in the manual for having your code generated.

 

X2C Demo board

X2C Demo board

Chipcad released a special X2C demo board! It is available with a 16bit dsPIC33EP256MC502 / 70MHz / 256kB Flash / 32kB RAM or a 32bit PIC32MX170F256B / 50MHz /256kB Flash /64kB RAM processor onboard.

 

STM32 Nucleo

STM32 Nucleo

The STM32 Nucleo evaluation board “NUCLEO-F072RB” uses a STM32F072R8 processor.
The USB interface is used to power the board and may be used for programming and communiation via an virtual serial interface.

 

BeagleBone Black

Beaglebone Black

The BeagleBone Black is a low-cost, community-supported development platform for developers and hobbyists yet it is powered by a hefty AM335X 1Ghz Cortex-A8 processor. A sound package of connectivity options rounds off this piece of hardware.

 

Arduino Due

Arduino Due

Arduino Due evaluation board with processor. USB interface is used for power supply and may be used for programming.

 

ST © STM32F0DISCOVERY

ST ©  STM32F0DISCOVERY

ST © STM32F0DISCOVERY with STM32F051R8 processor. USB interface is used for power supply and may be used for programming and debugging.
This board does not feature a (virtual) serial interface via USB port. To use communications functionality within our demo project, a USB-to-3.3V-TTL converter cable (e.g. the FTDI TTL-232R-RPI cable or Adafruit 954 cable) has to be used.
Connection setup:
* Rx-wire to board pin “PA9”
* Tx-wire to board pin “PA10”
* Ground-wire to any available “GND” board pin

 

Texas Instruments © controlCard

Texas Instruments © controlCard

Texas Instruments © controlCARD with TMS320F28069 processor plugged into the appropriate docking station (Docking-Stn USB-EMU). The USB interface may be used for power supply and for programming/debugging.
Alternatively, an external DC power supply can be used.

 

Texas Instruments © controlSTICK

Texas Instruments © controlSTICK

Texas Instruments © controlSTICK with TMS320F2808 processor.
USB interface is used for power supply and may be used for programming/debugging.

 

Texas Instruments © Tiva C Series Launch Pad

Texas Instruments © Tiva C Series Launch Pad

Texas Instruments © Tiva C series LaunchPad with TM4C123G processor.
USB interface is used for power supply and may be used for programming/debugging.

 

Microchip © Microstick

Microchip © Microstick

Microchip © Microstick with dsPIC33FJ128MC processor plugged onto a Microstick Plus Developement Board.
USB interface is used for power supply and may be used for programming/debugging.

Do you know HOTINT? Find out more on our open source tool for flexible multibody system dynamics simulation!


HOTINT

X2C and HOTINT are developed at LCM Gmbh


LCM

which is funded within the FFG COMET program

COMET

of the ministry BMVIT and BMWFJ of the Austrian government and the regional government of Upper Austria


Land OOe

Parts of the development have been funded within the regional development program Regio13 of the European Union


Regio13